1

Ive got a nes that does not work it appers that it is not dettecting the cart. Ive tryed blowing out the port with a compressor but that did not work. Any other sugestions?

Comments
  • 1
    open it, control each soldering joint and if found, solder it properly. but maybe only the pins are a little bit oxidized, then maybe a brush will help to clean them.

    at least that's what I would do in your case 😎
  • 0
    @2erXre5 will try that thanks
  • 0
    Cleaning Electronics with a compressor is a very bad idea. The act of compressing the air can add a static charge to the air and when blowing on electronics can actually cause an ESD. Hope you didn't fry your shit.
Add Comment